Bulk Aggregates for Patios in Garrett, IN

Indiana Rock Supply handles gravel and aggregate delivery in Garrett, IN for two kinds of buyers. Contractors building patios and driveways order by the ton, and homeowners topping a drive or bedding a walk order the same materials in smaller loads. Most of that work starts with #53 stone.

This is moraine country. Loamy to clayey glacial till sits under the rolling ground, broken by sandy and gravelly outwash plains that drain fast and hold a base differently than the clay around them.

Materials for Garrett Projects

On a Garrett patio or flatwork job, get the bedding layer right first. Under pavers and slabs, the base does the structural work and the bedding stone only levels the surface. Get the base right and the finish stays flat.

#53 stone is the standard Indiana base. It packs hard and carries a driveway, parking pad, shed base or patio base. Use it as a solid layer under pavers and compact it in lifts.

On top of that compacted base, you have a choice. Limestone screenings, also called stone screenings, are the bedding layer under pavers and flagstone. They are fine, they screed smooth, and they let you set units to a true plane.

For a drive that needs a tighter surface, #73 stone is a finer dense graded stone with a smaller top size that packs smooth. #73 stone also works as a topping over a compacted #53 base. For walkways and garden paths, walkway gravel gives a finer, walkable surface than a drive mix.

Drainage and sand round out most orders. Mason sand handles brick and block work and paver joints. Washed sand levels and beds under slabs. Where water needs somewhere to go, drain rock feeds French drains, foundation drains and downspout runs.

Ground and Conditions in Garrett

When a Garrett patio fails, a thin base is usually behind it. A paver job set on an inch or two of stone looks fine in July and shifts by the next spring thaw. The units rock, joints open and the whole field heaves at the edges.

The fix is depth and compaction. Excavate deep enough that your #53 stone goes down in lifts, then compact each lift before the next one. Screening goes on last, at bedding depth only.

Water is the other half of it. Water soaks away quickly through outwash sand and gravel, but it perches on the denser till and collects in kettle depressions, muck pockets and low ground around the lakes. Set your base over a drainage layer where the soil is tight.

Runoff after heavy rain gullies bare slopes on the rolling moraines and cuts into stream banks and lakeside soils. Rip rap armors ditch banks, culvert outlets and shorelines where that cutting starts.

Timing matters. Base and driveway work runs best from late spring, once till and low spots dry out, through fall. Frozen ground stops compaction through winter, and the freeze-thaw cycles soften till subgrades each spring.

Delivery to Garrett and the Surrounding Area

Order online and pick your quantity by the ton or by the cubic yard. The two are not the same measure, so decide which one your project math uses before you order.

To estimate, take length times width times depth in feet, then convert. A yard of most stone runs around 1.4 tons, but the exact figure depends on the material. The calculator on each product page does this for you.

Bulk delivery drops the load where the truck can reach on your site in Garrett. We also deliver across DeKalb County, including Auburn, Butler, Waterloo, Ashley and St. Joe.

Size Your Load Before You Order

Start with the calculator on the product page for the material you need. Enter your area and depth, and it returns the tonnage or yardage to order. When you know the number, place your order with Indiana Rock Supply and we will deliver it to your site in Garrett.