Bulk Aggregates for Pathways in Fairmount, IN

Order gravel and aggregate delivery in Fairmount, IN by the ton or the yard. Indiana Rock Supply delivers bulk #53 stone, sand, topsoil and decorative rock across Grant County. Shop online and pick your material.

Fairmount sits on flat, heavy glacial clay that holds spring rain. That ground decides what you put on top of it. Start with #53 stone and work up.

Materials for Fairmount Projects

Paths and walkways take a different mix than a drive. Fine, well-grading material packs tight underfoot and stays put. Here is what we stock for that work.

Stone Screenings are the fines you want for a walkway top. Spread them thin, wet them, and they lock into a firm surface that rakes clean. Use them for paver bedding too.

Walkway Gravel gives you a finer, walkable surface for garden paths and side yards. It sits best over a compacted base of #53 Stone, the dense graded base Indiana specs as No. 53.

3/8" Natural Pea Gravel brings rounded, mostly uncrushed stone for play areas and light drainage. It moves underfoot, so keep it off slopes.

#73 Stone is the finer dense graded size. Use it to top a drive or shoulder where you want a tight, smooth-packing surface.

For the heavy work, 3/4" Crushed Stone and #8 Stone handle drainage and drive topping. Rip rap armor goes to RipRap for ditch and culvert outlets.

Ground and Conditions in Fairmount

Our ground is a flat to gently rolling plain of dense glacial till. Loamy clay runs across central Indiana and turns heavier toward the northeast. Water has no easy outlet, which is why so much farmland here runs on tile drainage.

A thin base fails first. Spring thaw softens the subgrade, traffic ruts the stone, and the path pumps mud. Cold winters and repeated freeze-thaw heave drives on wet clay. Frost depth runs about 30 inches in the Indianapolis area, where the City of Lawrence requires footings at least 30 inches down. Deeper local requirements are possible toward the north, and the local building department sets the figure.

Fix it before you surface it. Excavate to a firm subgrade and compact #53 stone in lifts. A light path can take a thinner base; drives and pads need more. Screenings and walkway gravel go on top of that base, never straight onto clay.

Timing matters. Base and driveway work runs best from late spring, once saturated clay dries out, through fall. Frozen ground stops compaction all winter.

Delivery to Fairmount and the Surrounding Area

Choose tons or yards before you order. Stone and gravel sell by the ton. Sand, topsoil and mulch are easier to figure by the cubic yard. Both listings show on each product page.

Estimate with the calculator. Enter your length, width and depth and it converts to tons or yards for the material you picked. That saves a second trip and a short load.

We deliver bulk to Fairmount and Grant County, including Marion, Gas City, Upland, Jonesboro and Van Buren. The truck needs a clear route to the drop point and a firm spot to dump. Order online when your site is ready.

Questions from Fairmount Buyers

What should I have ready when the truck arrives?

Clear a wide path to the drop spot and mark overhead wires or low branches. The driver needs firm ground to back onto, so keep the area out of standing water. Pick a spot you can shovel from, not the far corner of the yard. Have someone home to point at the exact pile location if you can.

What is the best base under pavers in Fairmount?

Compacted #53 stone is the base. It is the dense graded stone Indiana specs as No. 53, and it packs hard over our clay. Set the pavers on a bedding layer of stone screenings, not on the base itself. Give the base a solid compacted depth for a walkway and more where a vehicle rolls.

Figure Your Quantity, Then Order

Measure the area, pick your depth, and run the numbers on the calculator before you buy. That gets you the right tonnage the first time. Indiana Rock Supply delivers bulk stone, sand and soil across Fairmount and Grant County. Place your order online when you are ready.