#53 Stone, Sand and Gravel Delivery in Greene County, IN
Planning a driveway, a patio base or a drainage run? Indiana Rock Supply handles gravel, stone and aggregate delivery in Greene County, IN, and #53 stone is the material most of those jobs start with. It is the dense graded base that packs hard under drives, pads and slabs.
Materials Delivered in Greene County
Start with #53 stone, also called 53 stone or #53 crushed limestone. 53 is the dense graded compacted aggregate used for base.
Order #53 Stone for driveways, parking pads, shed bases and the base under pavers and slabs. Compact it in lifts and it holds. For a finer, smoother surface on top, use #73 Stone, the crusher run size with a smaller top size.
For an existing drive that just needs a fresh surface, Driveway Gravel is the local standby. For paths and garden walks, Walkway Gravel gives a finer, walkable finish.
Drainage jobs take clean, single-size stone. #8 Stone is a common Indiana driveway topping and works in underdrains and pipe bedding. #57 Stone and Drain Rock handle French drains and foundation drains.
Finish work uses sand and soil. Mason Sand beds brick, block and paver joints. Washed Sand levels and beds under slabs. Top Soil rebuilds lawns and beds over heavy clay or thin rocky ground, and River Rock covers decorative beds and dry creek beds.
Ground Conditions Across Greene County
Around Greene County, drives that rut most often sit on a base that is too thin. Spread too little #53 stone over soft valley silt and the drive ruts, pumps and turns to mud by spring. In the hill country, a shallow layer over clay shears off on a slope.
Greene County spans two ground zones. Around Linton, Bloomfield, Jasonville and Worthington, you are on broad flat river valleys and old lake-bed flats of silt and clay, with sandy dune ridges beside the Wabash and White rivers. Low valley bottoms drain slowly and flood when the rivers run high, and many upland loess soils hold water near the surface in wet seasons.
Around Owensburg and Solsberry, the ground is mostly unglaciated hill country. Thin silty soils sit over sandstone, siltstone and shale on steep ridges, and red-brown clay covers the karst plain, where sinkholes, caves and sinking streams are common. Rain runs off steep slopes fast and collects in narrow valleys.
That drives material choices. On the flats, plan on a thicker compacted base and clean drainage stone so water has somewhere to go. On the hills, protect bare slopes before they gully, and never aim runoff at a sinkhole, because it can wash out fill or open a collapse.
Timing matters too. Build low river-bottom sites from late spring through fall once water drops and the silt dries.
Delivery Across Greene County
Ordering online comes down to one decision first: tons or yards. Stone and gravel are sold by weight, sand and soil by volume, and the two are not the same number. A yard of #53 stone weighs more than a yard of topsoil, so check which unit the material lists before you size the load.
To estimate, measure length times width times depth in feet, then divide by 27 for cubic yards. For a compacted base, plan a solid finished thickness and buy for that compacted layer, not the loose pile, since stone settles as it packs. Ordering by the ton is usually the cleaner way to buy dense graded stone for a base.
Once you order, a bulk truck delivers and dumps on site. Here is what to have ready: a clear, firm spot for the pile, enough width for the truck to reach it, and a plan for where the material goes next. Keep the pile off soft ground in wet months.
Choosing the Right Material
Monroe County and Lawrence County sit in South Central Indiana, both in the same south-central hills and karst country zone as Greene County's Owensburg and Solsberry side. The ground is similar there, so the choice shifts with the project rather than the soil. A steep ridge drive in that zone still wants #53 stone over a stripped, compacted subgrade, with clean #8 stone handling the drainage.
Owen County shares that same hilly karst ground, with thin silty soils over sandstone and shale and red-brown clay over limestone. On that kind of site, keep the base on the ridge and send water to daylight instead of into a sinkhole.
Greene County's other half is different. The flat valley ground around Linton and Worthington has no counterpart in those three counties, and it changes the answer. Silt and clay flats need a thicker compacted base and more clean drainage stone, so lean on #53 stone and #8 stone rather than a thin layer of surface gravel.
Get Your Greene County Material Figured Out
Use the calculator to turn your measurements into tons or yards, then pick the size that matches the job. #53 stone for base, #8 stone or drain rock for water, sand and topsoil for the finish. Indiana Rock Supply delivers bulk loads across Greene County.