Skip to main content
FREE Delivery!|(812) 721-8126
Gibson County, IN Gravel and Landscape Rock Delivery

Gibson County, IN Gravel and Landscape Rock Delivery

Indiana Rock Supply handles gravel, stone and aggregate delivery in Gibson County, IN for two kinds of buyers: contractors building drives and pads on a schedule, and homeowners fixing one wet spot or one driveway. The material that carries most of those jobs is #53 stone, the dense graded crushed limestone that packs hard and stays put.

Materials Delivered in Gibson County

Start with #53 stone for any base that has to hold. Indiana specifies it as compacted aggregate No. 53 in Section 904 of the Standard Specifications, so your engineer or inspector will call for it by that number.

Around it, the rest of the list covers surfacing, drainage, bedding and planting.

Drainage work usually pairs #8 stone with #57 Stone or #4 Crushed Stone in the trench, and finishes with Stone Screenings for bedding under a patio or walkway. Decorative work runs to River Rock, Large River Rock for dry creek beds, and Natural Pea Gravel for paths and play areas.

Ground Conditions Across Gibson County

The failure mode here is a thin base over soft, wet silt. Drive on it in spring and the stone punches down and the edges break away. The fix is depth and separation, not more surfacing. Build #53 stone in compacted lifts to a real depth, and place a drainage layer where the subgrade will not dry.

Low valley bottoms and old lake-bed flats drain slowly and flood when the Wabash, White, Patoka or Ohio rivers run high. On those sites, crown the drive, ditch both sides, and run drain rock where water collects. Many upland loess soils have a fragipan that holds water near the surface in wet seasons, so a French drain or an underdrain of #8 stone is often the only thing that dries a yard out.

Erosion is the other local problem. Bare loess washes fast once its cover is stripped, and river and ditch banks cut during floods.

Timing matters. Winter and spring are the high-water months on the river bottoms, so low sites build best from late spring through fall once water drops and the silt dries.

Delivery Across Gibson County

Ordering online comes down to one decision first: tons or yards. Bulk aggregate is sold by weight, and yards are a volume measure, so the same pile changes number when you switch. Weight is the safer way to order a compacted base, because a yard of #53 stone weighs more than a yard of Natural Pea Gravel.

Estimate depth first, then area. A driveway with a thick compacted base needs more stone than the same area with a thin layer, and compaction changes the figure again. Add a little for spill and for the soft spot you find halfway through.

We deliver to Princeton, Fort Branch, Oakland City, Haubstadt, Owensville, Patoka, Francisco, Hazleton and Buckskin. A bulk delivery means a truck has to reach the pile site, so clear the route and pick a spot you can back into.

Have the site ready before the truck arrives. Know where the pile goes, keep vehicles and kids clear, and if you are spreading right away, have the machine on hand so the stone does not sit in the way.

Choosing the Right Material

The right material shifts a little as you cross the county line, and the neighbouring counties show why. Vanderburgh County sits in the same Southwest Wabash and Ohio lowlands ground zone, so the ground is similar to Gibson County. The work there leans toward tighter urban lots and short drives, where #53 stone still carries the base and a clean stone like #8 handles the tight drainage runs.

Warrick County shares that same ground zone and the same broad river valley and loess hills. The ground is similar, so the choice comes down to the project. If a yard there floods like a low bottom here, the answer is the same drain rock and underdrain setup. If it is a new drive, the answer is a compacted #53 base with a #73 or driveway stone surface.

Pike County also falls in the Southwest Wabash and Ohio lowlands zone, with the same thick wind-blown silt over older ground. Drainage decisions carry the same weight.

So the pattern holds across the region: dense graded #53 stone for anything that has to hold weight, clean stone for anything that has to move water, and riprap for anything that has to stop a bank from washing. Match the material to the job and the local ground does the rest.

Get Your Gibson County Order Sized and Delivered

Run your square footage and depth through the calculator before you order, and let it hand you the tonnage for the material you picked. That one step saves a second trip and a short pile.

Frequently Asked Questions

Common questions about gravel and aggregate delivery in Gibson County

Should I order material by the ton or by the yard?

Bulk aggregate is priced and hauled by weight, in tons. Yards are a volume figure, so they change with the material: a yard of dense #53 stone weighs more than a yard of Natural Pea Gravel. If you know your square footage and target depth, use the calculator to convert.

Which stone is best for drainage in Gibson County?

Use clean, single-size stone so water has open space to move. #8 stone is the common pick for underdrains, pipe bedding and French drains, with #57 stone or #4 crushed stone where the trench is deeper or the flow is heavier. Add drain rock at downspout runs and low spots.

What do I need to have ready for a bulk delivery?

Have a clear, firm route the truck can use and a spot you can back into. Mark where the pile goes and keep it close to the work but off the drive and away from tile, meters and overhead lines. Move vehicles and keep people clear while the bed is raised.