Skip to main content
FREE Delivery!|(812) 721-8126
Order #53 Stone and Crushed Stone in Fulton County, IN

Order #53 Stone and Crushed Stone in Fulton County, IN

Indiana Rock Supply handles gravel, stone and aggregate delivery in Fulton County, IN for two kinds of buyers. Contractors order by the ton for drives, pads and drainage, while homeowners order a single load for a shed base or a garden path. Both usually start with #53 stone, the dense graded base that packs hard under almost everything.

Fulton County ground is rolling moraine ridges of loamy to clayey till, broken by sandy and gravelly outwash plains. That mix decides which material works and which one just sits there.

Materials Delivered in Fulton County

Most jobs here fall into four families: base stone, washed stone, sand, and soil or fill. The table below shows what each one does on a Fulton County job.

#53 stone carries the most weight here because it does the most work. It is a dense graded stone with fines, so it compacts into a firm, nearly concrete-like layer. 53 in Section 904 of the Standard Specifications, which is how the size is named on local plans. Order it for a new drive build, a parking pad, a shed base, or the layer under pavers and slabs.

Above that base, buyers often switch to #73 stone for a smoother wearing surface, or to driveway gravel to freshen an existing drive. Where water needs to move rather than sit, #57 Stone and drain rock are the usual picks.

Ground Conditions Across Fulton County

Start with where the water goes. Rain and snowmelt soak away quickly through the outwash sand and gravel, but they perch on the denser till and collect in kettle depressions, muck pockets and low ground around the lakes.

That split drives base depth. On a sandy outwash plain, a compacted #53 layer can be thinner because the subgrade drains. On a till ridge or near a muck pocket, plan on more depth and expect the subgrade to stay soft longer in spring.

Runoff after heavy rain gullies bare slopes on the rolling moraines and cuts into stream banks and lakeside soils. Rip rap and large river rock armor those spots before the next storm takes more ground.

Timing matters as much as material. Base and driveway work runs best from late spring, once till and low spots dry out, through fall. Frozen ground stops compaction through winter.

Cold winters bring repeated freeze-thaw that heaves gravel drives and softens till subgrades each spring. Fulton County sits among the deeper frost depths in Indiana, and the exact footing depth is set by the county or city building department.

Delivery Across Fulton County

You order online and the material arrives in bulk, sized by the ton or by the yard. Bulk delivery means a truck that needs room to turn and a place to dump, so plan the drop before the load is scheduled.

For a smooth drop, have the spot clear, firm and reachable by a loaded truck. Mark any septic lids, sprinkler heads or buried lines, and tell us if the drive has a soft shoulder or a low wire. If the truck cannot reach the work area, pick a staging spot close by and plan to move material from there.

We deliver to Rochester, Akron, Kewanna and the surrounding parts of the county. If you are unsure how much you need, measure the length, width and depth of the area and use the calculator to size the load.

Choosing the Right Material

Ground next door is not the same as ground here. Cass, Miami and Wabash counties all sit in the Central and northeast till plain, a flat to gently rolling plain of dense glacial till with heavier clay toward the northeast and sand and gravel outwash along the larger river valleys. Fulton County's moraine ridges and outwash plains are similar ground, so the material logic carries over.

The practical difference is how much of each you meet. On flatter till plain ground, drainage is the bigger problem, so a clean stone layer under a compacted base earns its place. On Fulton County's rolling ridges and outwash, you may get good natural drainage on one part of a job and a wet pocket on the next.

Match the material to the job rather than the county line. A patio wants #53 stone compacted below and screenings or washed sand for bedding. A drive wants #53 stone below and #73 stone or driveway gravel on top. A wet low spot wants drain rock or #8 stone, not more fines.

Order Stone and Aggregate for Your Fulton County Project

Indiana Rock Supply delivers #53 stone, washed stone, sand, topsoil and rip rap for driveways, parking pads, shed bases, patios, drainage and shoreline work across Fulton County. Contractors and homeowners order the same way, online and by the ton. Pick the material for the project and a drop spot the dump truck can reach, then place your order.

Towns we deliver to in Fulton County

Frequently Asked Questions

Common questions about gravel and aggregate delivery in Fulton County

What do I need to have ready for a bulk delivery?

Have the drop spot clear, firm and reachable by a loaded truck. Mark septic lids, sprinkler heads and buried lines, and note any soft shoulder, low wire or tight gate. If the truck cannot reach the work area, choose a staging spot close by. Tell us about access limits when you order so the driver can plan the approach.

What is the best base material for a patio in Fulton County?

#53 stone is the standard choice. 53, and it packs hard under pavers and slabs. Compact it in lifts, then bed the pavers on stone screenings or washed sand. On softer till ground, dig deeper and build the base thicker.

Can I order material for a commercial or contractor job?

Yes. Contractors order bulk #53 stone, washed stone, sand and fill for drives, pads, drainage and site work across Fulton County. Order by the ton or yard, and size each load to the phase of the job. Give us the area dimensions and depth, and we will help you work out the quantity.